ItzStreetLethal
July 7th, 2009, 09:40 AM
I have a ton of parts that I'd like to get rid of. I'll list everything that comes to mind and would like to sell it as a complete package. I don't know the value of each little part and am asking a total price, if that makes sense. So here goes...
Dejon 2G MAS to 14b turbo inlet pipe
UNI 2G air filter
K&N 1G air filter
ADJ Fuel Pressure Regulator (DSM type, bolts in OE location) **SOLD**
Unorthodox UD Crank Pulley **SOLD**
Electric Fan (aftermarket but origins unknown)
T25 (history unknown)
Cat back exhaust (see below for condition) **SOLD**
1G DSM turbo head (history unknown, but was told it skipped) **SOLD**
1G DSM valve cover (currently on head, go figure) **SOLD**
5spd AWD trans (condition unknown) **SOLD**
Crank (guessing 4G63/2.0L) **SOLD**
Cams (I think I have two sets, some with surface rust :cry:)
A/C Compressor X 2 (several misc lines as well)
Clutch slave
Clutch master with res
Radiator hoses (look pretty new actually)
Pulleys, mounts and brackets (seem like enough for several 4G's!)
Piping (mostly OE but Dejon UIP and couplers as well)
Water pump
Power steering pump
OE fuel pressure regulator
Thermostat housing
Winshield washer fluid containers (front and rear)
Coolant overflow bottle
Cruise control w/cables
Starter
2 WG actuators (one for the T25 I believe)
1G exhaust mani
Timing belt covers (lower, in two parts and rough shape)
Alternator
Cam Angle Sensors (2)
2 OE Intake mani's
OE Battery tie-down and maybe even the tray
2G knock sensor (looks lightly used)
A few fuel filters
Oil filter housings (at least 2)
Ignition module (not coils!)
Chiltons 90-98 DSM manual (grease included at no extra charge)
2 OE 6X9 speakers
20G Compressor housing
14b Compressor housing
14b Exhaust housings (one w/crack, one welded for EWG)
2 OE SMIC
2 Swirl/turbo TSI rims (solid)
2 1G side mirrors
1G center console
1 Pass side lens cover
Dipstick **SOLD**
Center A/C vent
1G shift lever and donkey dong knob
That's probably 95% of things... So I'm asking $500 for everything to be picked up (may require the use of a TRUCK!!!).
Oh and I have a melted 4G63. :barf: Had 272s, rods, pistons, custom tubular mani and whats left of a GT30. It's yours for the taking as well, doubt anythings useable though. The fire was hot enough to melt the intake mani and compressor housings! **GONE** Anyways, I'm in Melbourne just hit me up on PM or better yet, email to Mothecat417 at AOL dot com. Thanks...
Dejon 2G MAS to 14b turbo inlet pipe
UNI 2G air filter
K&N 1G air filter
ADJ Fuel Pressure Regulator (DSM type, bolts in OE location) **SOLD**
Unorthodox UD Crank Pulley **SOLD**
Electric Fan (aftermarket but origins unknown)
T25 (history unknown)
Cat back exhaust (see below for condition) **SOLD**
1G DSM turbo head (history unknown, but was told it skipped) **SOLD**
1G DSM valve cover (currently on head, go figure) **SOLD**
5spd AWD trans (condition unknown) **SOLD**
Crank (guessing 4G63/2.0L) **SOLD**
Cams (I think I have two sets, some with surface rust :cry:)
A/C Compressor X 2 (several misc lines as well)
Clutch slave
Clutch master with res
Radiator hoses (look pretty new actually)
Pulleys, mounts and brackets (seem like enough for several 4G's!)
Piping (mostly OE but Dejon UIP and couplers as well)
Water pump
Power steering pump
OE fuel pressure regulator
Thermostat housing
Winshield washer fluid containers (front and rear)
Coolant overflow bottle
Cruise control w/cables
Starter
2 WG actuators (one for the T25 I believe)
1G exhaust mani
Timing belt covers (lower, in two parts and rough shape)
Alternator
Cam Angle Sensors (2)
2 OE Intake mani's
OE Battery tie-down and maybe even the tray
2G knock sensor (looks lightly used)
A few fuel filters
Oil filter housings (at least 2)
Ignition module (not coils!)
Chiltons 90-98 DSM manual (grease included at no extra charge)
2 OE 6X9 speakers
20G Compressor housing
14b Compressor housing
14b Exhaust housings (one w/crack, one welded for EWG)
2 OE SMIC
2 Swirl/turbo TSI rims (solid)
2 1G side mirrors
1G center console
1 Pass side lens cover
Dipstick **SOLD**
Center A/C vent
1G shift lever and donkey dong knob
That's probably 95% of things... So I'm asking $500 for everything to be picked up (may require the use of a TRUCK!!!).
Oh and I have a melted 4G63. :barf: Had 272s, rods, pistons, custom tubular mani and whats left of a GT30. It's yours for the taking as well, doubt anythings useable though. The fire was hot enough to melt the intake mani and compressor housings! **GONE** Anyways, I'm in Melbourne just hit me up on PM or better yet, email to Mothecat417 at AOL dot com. Thanks...